'07 Prowler jetting at 7500 ft. ?

[RathrBdunin]

Our Prowler is bone stock engine/carb. We are going up to the rim area at 7500+ ft. I am getting concerned if this thing will run worth a crap in stock jetting form ?
I have done nothing with it yet. It feels a little rich in stock form to me at our house where we buzz around. We are at 2500 ft. and I am referring to strickly seat of the pants feel ;) I plan on spending some time with it one of these times to dial it in perfect. Just have not got to it jet - Have not even pulled the plug to see how it looks.[:0]

Any experiences at elevation with your stock Prowlers ?

Thx,

I did a plug check it looks like it is burning great for our
2500'-2800' with stock jetting.

[chmoser]

I've had no problem with the jetting in my Rhino. I have used my stock main jet from 700 ft- 8,300 and ran good all in between. I will be going up to Co. next wek and I know from my bike trips up there before that I'll need to jet down, Had to drop 2 sizes on my bike and ran great from 9,400-11,000 ft. I just droped two sizes in my Rhino for a starting point, and I think that should be good, but have other jets on hand. Takes me about 10 min to rejet my Rhino carb.
Chris... topherztoyz

[azotto]

Quadman20 ran his Prowler up there last summer without re-jetting. Said it was a little sluggish but not to bad.

[RathrBdunin]

Thanks for the note. after checking the plug down I think it will be fine also.
Thx,

[quadman20]

Yep runs fine up north even at 8413 feet. Unless you live at 5000' or better all the time I wouldn't do it or you'll real lean at 2000'